The pump’s cutting mechanism ensures long fibers and soft solids are shredded before discharge, preventing pipe blockages and reducing maintenance costs. Problem Possible Cause Solution Pump won’t sta…
| Flow Rate | 10-300m³/h |
|---|---|
| Head | 10-30m |
| Power | 0.75-22kW |
| Inlet / Outlet Diameter | 50-200mm |
| Material | Cast Iron,SS304 |
The pump’s cutting mechanism ensures long fibers and soft solids are shredded before discharge, preventing pipe blockages and reducing maintenance costs.
| Problem | Possible Cause | Solution |
|---|---|---|
| Pump won’t start | Power not connected / phase loss / impeller stuck | Check wiring, adjust impeller gap to 0.2–0.5mm |
| Low flow or head | Impeller worn / reverse rotation / low voltage | Replace impeller, swap two phase wires, adjust voltage |
| Poor cutting performance | Gap too large / blades dull | Adjust gap, replace impeller and bottom plate |
| Protector trips repeatedly | Low insulation / motor overload / phase failure | Dry motor, check voltage, clean debris |
Maintenance Tips:
•
After pumping thick slurry, run pump in clean water for a few minutes
•
Change oil every 300–500 hours (use #10 machine oil)
•
Check insulation resistance regularly (min 0.5 MΩ)
•
Test seal integrity at 0.2 MPa after repair
WQK Cutting Blade Sewage PumpEven the best chopper pump can develop issues. Here are five problems I’ve seen most often with WKQ/QG series pumps and how to fix them. Problem 1: Pump Runs But No WaterCause: Vapor lock or blocked…
WQK Cutting Blade Sewage PumpHeadworks are the front door of a wastewater treatment plant. Everything that comes down the sewer arrives here — rags, plastics, sanitary products, you name it. A chopper pump at this stage saves th…
WQK Cutting Blade Sewage PumpFarm waste is different from municipal sewage. It’s thicker, more fibrous, and loaded with bedding material like straw and hay. An agricultural chopper pump needs to handle all of that without cloggi…