تضمن آلية القطع الخاصة بالمضخة تمزيق الألياف الطويلة والمواد الصلبة الناعمة قبل التفريغ، مما يمنع انسداد الأنابيب ويقلل تكاليف الصيانة.
Problem
Possible Cause
Solution
Pump won’t start
Power not connected / phase loss / impeller stuck
Check wiring, adjust impeller gap to 0.2–0.5mm
Low flow or head
Impeller worn / reverse rotation / low voltage
Replace impeller, swap two phase wires, adjust voltage
Poor cutting performance
Gap too large / blades dull
Adjust gap, replace impeller and bottom plate
Protector trips repeatedly
Low insulation / motor overload / phase failure
Dry motor, check voltage, clean debris
نصائح الصيانة: • بعد ضخ الملاط السميك، قم بتشغيل المضخة في ماء نظيف لبضع دقائق • قم بتغيير الزيت كل 300-500 ساعة (استخدم زيت الآلة رقم 10) • تحقق من مقاومة العزل بانتظام (0.5 ميجا أوم كحد أدنى) • اختبر سلامة الختم عند 0.2 ميجا باسكال بعد ذلك. إصلاح